Recent content by londonboy

HI All I am still getting the channel change issue (it never went away really but became so infrequent as to be not a problem) Not so now-it does it all the time and now at high and low speeds as to render box unusable-just got the YV box swapped and still does it. I have tried everything...

I never really got to the bottom of what was causing it. It was a major pain in the ass and turned into a very complex test of many things slowly trying to eliminate various causes. I would take out the aerial and HDMI leads and block off the IR pick up and see if the problems still happens...

I just got my youview box and its doing the same channel swapping. I have done extensive testing and "I think" narrowed it down to a bad hdmi lead. have swapped lead out and so far no probs. will let you know how it pans out. Apart from the channel changing which it would seem is not humaxs...

cheers for the info EP. will hold on to t2 and trial you view. in the end one will go ebay. at £110 I can take the risk and maybe even make on the youview and leave the BT account dormant. shame you cant manual tune or edit channel on you view-how ridiculous. a real drag. im sure life was...

Because of the fault on my humax as stated above I started looking around at new humax stuff. I found out I can get BT vision which gives me a free humax you view box for a £110 charge (set up and years rental) I have just ordered it and will check this unit out and probably end up ebaying the...

Humax said to me it sounded like a main board fault. Its weird as i had the issue on a 9200T in another property and a factory reset/HD format/firmware reflash and retune sorted it. Humax said its a rare fault on the foxt2, but i guess they would say that as they sell it. good luck with...

Humax are taking unit back on a warranty return. They did ask me to do the following 1: check remote buttons not stuck and remove batteries 2: hold down ok and zero. after 20 secs it will ask to change remote IR frequency. none of the above helped me but may be of use to people in the...

I have tried factory reset but problem still there. guess its a fault with the unit. will call up humax and have a chat see whats up. thanks anyway for 4 the help folks.

I think its a scrambled epg but its just a hunch. I will re flash the firmware and see what happens. any other help from anyone is appreciated.

Nothing scheduled. Still changes when ir covered. Doing it about 5 times a minute.

My T2 is changing channels by itself. I have done a retune and its still doing it. does anyone know how i can fix this. any help appreciated as getting no joy from web search