Ah!!! Thanks for that Ezra. I did notice the list of backups on the Scheduled Recordings page but I thought these had something to do with the daily OTA communications. It's the old story, sometimes you can think about things so much you end up overlooking the bleeding obvious!!!
I do apologise in advance if this is so basic that it's been covered elsewhere, but I promise I have looked in the forum and Wiki :). I am aware that re-tuning and OTA updates if enabled wipe out the recording schedule and that these can be restored from the custom firmware if a manual backup...
Thanks for the advice. Reinstalled CF - problem solved! Will now follow the advice re the OTA updates as I didn't realise these overwrote the installation.
Hi prpr, no, just "Ver a7.30" as it has always done. Other info from System Information:
Software Version FHTCP 1.03.12
System ID 80BC.7E00
Update Date 07 FEB 2014
MICOM Version 9.3
Mac Address 00:03:78:B9:2D:29
It is a good few months since I last accessed my HDR Fox T2 via the custom firmware. Having tried to access it today, the IP address (192.168.1.64 as shown in the menu) is showing as "not available". The HDR is showing on my network map, I can successfully ping the IP address through the...
Just thought I would update you on this. After above posts, just gave up and watched in SD. Today gave it another go - at first, still nothing on HD, then noticed that the HD channels were all set to Transmission Type DVB-T. Changed this to DVB-T2 and they're all back - signal strength 24%...
Of course, you're right, and I don't think it has an HD tuner. What I don't understand, though, is why HD reception was perfectly possible up until a few days ago. That means I must have a suitable aerial - signal strength and quality showed the same for both HD and SD. In the absence of any...
Thanks Martin & Sam. There is no apparent aerial damage. Pontop Pike is a good few miles from me, but there are certainly no nearby trees that have sprung up. I understand that Pontop Pike's SD and HD transmissions are both at the same strength, but my SD quality is unchanged. I have...
Hi,
This is my first post here and hoping someone can point me in the right direction. I have owned my box now for about 6 months without problems. Less than a week ago, the HD channels started pixellating a little. This gradually increased until now they are not showing at all. I confirmed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.