Recent content by matt

I've got mine set for auto decrypt and shrink but unfortunately this was all done under 0.10-2 I'm guessing I need to run a stripts -F on all of the files that have already been decrypted and shrunk?

Just had a quick look at mine. I do tend to leave it on most of the time hence substantial number of power on hours.. IDNameFlagsRaw ValueValueWorstThreshTypeUpdatedWhen Failed 1 Raw_Read_Error_Rate POSR-- 188697770 118 099 006 Pre-fail Always - 3 Spin_Up_Time PO---- 0 097 097 000 Pre-fail...

I thought that too. I have got the streaming going by decrypting and then stripts -Fv filenamein filenameout from an ssh shell. b

Its been a few months since I last thought about trying this. Has anyone had any success recently with getting it working?

Just compiled ethtool, virtually every command you run against it give operation not supported apart from: humax# ./ethtool -i eth0 driver: BCMINTMAC version: 2.0 firmware-version: bus-info:

yup installed gawk and it works, thanks af123. Just building ccache http://ccache.samba.org/ if you want it?

I found the following like in my configure script: line = substr(line, 1, len) "" value "" substr(line, len + keylen + 3) Changed it to: line = substr(line, 1, len) "" value "" Things look correct for my example above but I'm looking at the implications of this change now

Got similar issues with compiling ccache 3.1.4 the makefile configure generates has some issues. An example of where it goes wrong: Makefile.in has this line: CC = @CC@ Generated Makefile has this line: CC = gccCC@ So its not removing the whole token just the first fraction of it

Is this the same as yours: humax# cat /etc/profile # ~/.bashrc: executed by bash(1) for non-login interactive shells. export PATH=/mod/bin:/mod/usr/bin:/mod/bin/busybox:/bin:/sbin export LD_LIBRARY_PATH=/mod/lib:/lib:/usr/lib ulimit -S -c 100000000 umask 077 # If running interactively, then...

When logging in with putty to dropbear-ssh I get the following: login as: zero Authenticating with public key "dave" Passphrase for key "dave": -sh: ulimit: line 6: error setting limit (Invalid argument) humax# Is this something I need to sort out or do I just need to ignore it ?:)

Just had to do a couple of bits to get up and going after installing the firmware@ make a /mnt/hd2/mod directory run /sbin/modinit Great work chaps :)