• The forum software that supports hummy.tv has been upgraded to XenForo 2.3!

    Please bear with us as we continue to tweak things, and feel free to post any questions, issues or suggestions in the upgrade thread.

Recent content by phit03

  1. P

    Visual Schedule not Showing all Recording Conflicts

    Web interface version: 1.5.3 Custom firmware version: 3.13 (build 4028) Humax Version: 1.03.12 (kernel HDR_CFW_3.13) Remote Scheduling shows the correct info.
  2. P

    Visual Schedule not Showing all Recording Conflicts

    The Visual Schedule screen does not seem to show all conflicts that are in the schedule. I use Visual Schedule to check programs added to the schedule for conflicts as I can use it as a single stop tool to resolve conflicts when they occur. In some situations it fails to show conflicts that can...
  3. P

    CH48 interference on HDRFOX-T2 Boxes

    Yes, it should say CH48.
  4. P

    CH48 interference on HDRFOX-T2 Boxes

    Thanks everyone for your time invested in looking at my problem with failed recordings with programs on the CH58 MUX on the HDRFOX-T2 PVRs during periods of atmospheric ducting and providing your inputs. It seems from your responses that the problem could be alleviated by making changes to my...
  5. P

    CH48 interference on HDRFOX-T2 Boxes

    Problem with this approach is that i would need a passive splitter or splitters to provide a UHF signal to 9 devices in one room and 5 devices in the other. Would the insertion losses caused by this amount of passive splitting be workable? Also, would this would mean that I would need an active...
  6. P

    CH48 interference on HDRFOX-T2 Boxes

    Thanks, I'll have a look to see what it says.
  7. P

    CH48 interference on HDRFOX-T2 Boxes

    Yes, the problems seem to occur evenings and mornings. I think the aerial is less than 10 metres above ground level but not much less (2 story building with the aerial close to the apex of the roof in the loft) and points through a single layer brick gable end (timber frame construction with a...
  8. P

    CH48 interference on HDRFOX-T2 Boxes

    Thought I might try this to see if it makes any difference: Labgear 5G/LTE 700 Interferace Filter , with Coax flylead...
  9. P

    CH48 interference on HDRFOX-T2 Boxes

    See my reply to Rodders53 for more info on my setup. I freely admit my ignorance of signal reception but I seem to remember that you can have problems with harmonics from other frequencies causing interference. However, thinking about about it, no amount of filtering will have any affect in...
  10. P

    CH48 interference on HDRFOX-T2 Boxes

    As mentioned in the post, a Humax FVP5000T Freeview box and 4 network connected HDHomeRun boxes (plus an LG and Samsung TV) connected to the same aerial feed are not affected to the same degree (some pixellation but able to view the program) by interference during periods of "abnormal"...
  11. P

    CH48 interference on HDRFOX-T2 Boxes

    Apologies if I posted on the wrong forum, it says "HDR-FOX T2 Freeview Recorder at the top of the thread" did someone move it to the correct forum for me?
  12. P

    CH48 interference on HDRFOX-T2 Boxes

    I have a problem with the BBC MUX that is on CH48 on the Midhurst Transmitter on my HDRFOX-T2 boxes, usually at times of high pressure weather patterns with loss of signal for programs on that MUX. I either lose the feed for programs on that MUX completely or get very poor signal strength...
  13. P

    Change the network default Gateway using the CLI

    Sorry folks, suffering from brain fade. Discovered there's a setting in the CFW that allows me to change this under Network Settings.
  14. P

    Change the network default Gateway using the CLI

    I want to change the default gateway on a HDRFOX-T2 with the CFW that has the "green screen" problem. I can use the CLI to change it but it gets reset to the old gateway address after a reboot. I presume that the default gateway, along with the other network parameters is held in NVRAM and gets...
  15. P

    Retune HDRFOX-T2 Remotely Using Telnet/CLI

    I'm pretty sure the answer is no but I'll ask anyway just in case. Since the recent channel changes for SKY Mix/Sky Arts I no longer have access to SKY Arts. I'm not in the UK at the moment so can't retune via the box using it's remote control. I had hoped that Tunefix might be able to handle...
Back
Top