Recent content by RobUK

Hi everyone, My Humax 2000T box recently seemed to lose BBC1 , BBC2 and CBBC. The HD versions are still available. The Humax box complained about poor signal. I've tried an auto-retune and now these channels are not listed in the guide at all. I've also looked at...

Those are the Reigate channels I think, however i think you are right I should be using CP since most of the Auto Search channels are from there. For the time being I've deleted the channels that are coming in on Channel 21 and did a manual search on 25. It seems to have picked everything back...

Thanks, I just made an edit to that post, am I right about the delete and manual tune option if channel 21 is currently receiving poorly?

How accurate is the coverage predictor? If I'm understanding it correctly then it suggests the Crystal Palace transmitter is ever-so slightly better than the Reigate transmitter, despite it being further away. I am based in Crawley, postcode RH10

As far as i can tell from that checker I should be using channels 21- , 24, 27, 53, 57, and 60- What does it mean by 21+ and 60- ? I am already picking up channel 21, it seems to be the lowest strength one I have. If I'm following this properly I could delete all the channels that channel 21...

Here are the current settings. All say Quality 100% Channel - Strength 21 - 10 22 - 46 23 - 46 25 - 44 26 - 44 28 - 45 30 - 49 (DVB-T2) 33 - 41 (DVB-T2 )

Thanks, I'll check again when I get back home. I recall spot checking a few of then, some had strength around 40%, others were down around 10%. Can I force the box to use the Reigate transmitter ( whic is my nearest) when searching for channels?

Hi there, I just received one of these last week and yesterday I swapped it out for the old 9200T I had. I notice that some channels stop working after a while saying that the signal is bad. Is there anything I can do on this? I don't recall an issue with the old box plugged into the same...

Thank you! Is this something I could do in dribs and drabs, i.e. start using the 2000T as a completely empty device and then gradually add the programs from the 9200T as I go, or will I have to get everything moved across before I start using the new one?

I've just ordered the 1Gb version of the 2000T device to replace my ( now rather fragile) 9200T . Is it possible to get the recordings off the old box and onto the new somehow? R