9300T Problems after switching off.

SmarttramS

New Member
I am wondering if someone could tell, or put me on the right track. Have just bought a 9300T and while watching with the Tv+PVR hooked up together, a good picture all round, but when I swith the PVR off , all I get on my TV is (No Signal)
I had a 9150T before and everything was okay while watching, and swithed off PVR
 
There should be a setting somewhere for power saving in standby, you need to turn this off.
 
If power-saving is turned off then the antenna feed should passthrough the humax as with your 9150 (and all other humaxes).

Are all your cables ok? Try swapping them around to see if you still have the same fault?

I assume a direct feed to your TV works.

Do you have an masthead amplifier powered via the antenna cable?

Martin
 
Well thanks for your reply's lads. But I cant say what it was, as I have disconnected everything(cable wise) Re-factory -tuned the TV and then connected all the cables and everything seems to be working now.
But thaks again.
 
Back
Top