Using more than 1 Humax box in the same room

Status
Not open for further replies.

grahamlthompson

Well-Known Member
#1
Using more than 1 Humax box in the same room

From the Hummy.org.uk site, that is now suspended: Originally posted by Barry

Multi Code function HDR remote
--------------------------------------------------------------------------------
Revealed exclusively to Hummy.org members.
If you are using more than one receiver in the same location you can change the remote control frequency so that the remote control commands do not conflict.

This is relevant to the following Satellite Products,
Foxsat HD, HDR, HDCI 5000, HDR-1000/1010/1100S, HB-1000S

Also relevant to the following Terrestrial Products,
HD/HDR-FOX T2, HDR-1800/2000T, FVP-4000T

1. Switch on your TV set and the Humax product that you wish to change the remote code.
2. Make sure that the other Humax product that you do not wish to control is in Standby or powered OFF at the mains.
3. Point the remote control towards the remote control sensor of the target receiver.
4. Press and hold the 0 and OK buttons simultaneously for 5 seconds until the PVR button on the remote stays red.
5. A message will appear on the TV screen:

"You can change the remote control mode.
Press a Numeric Key (<1> ~ <6>) to select the mode
Current mode: Mode 1."

6. Press a NUMERIC button (from 1 to 6) to select a different mode.
7. A message confirming the change of Mode will appear on screen.
 
Last edited by a moderator:
Status
Not open for further replies.
Top