Recent content by Andybrody

Thank you, that did the trick;) Andy

Hi MymsMan thanks for the reply, Do I just copy/paste the command line into Run Diagnostic: general box the run diagnostic. Thanks again Andy

Hi all, been a while since I've been on here. Over the last couple of days have had the Temp over 50c warning on display. When into WebIF and found that the HDR had crashed. Carried out a Fix-Flash-Packages Diagnostic. Now the Temp problem appears to have been sorted has not shown up and has...

Thank you

Hi All, my Plusnet 2120 YouView has started playing up think its probably a power fault. Started to cause problems with Aerial Amp feed thru to my T2, intermittent picture break up and loss of signal. Later total loss of RF feed thru. So I Switched the power switch on rear on and off. Has been...

Thanks for you response all seems to be ok now.

Think I Think Ive sussed this now, HDR has crashed twice unbeknown to me and probably disable the FanPackage, then the unit overheated 55+ degrees and for some strange reason I could not access it from laptop (but could from lounge HDR). Unit has been running now for almost 2 hrs and temp has...

Found Mac Address now

Just looking at doing this, I cant remember where I'll find the The Mac Address can you nudge me in the right direction please :)

Good Idea Ill give it a go later thanks for the advice.

I allowed the HDR to cool down for about an hour and can now log back in. When I did found the following Pending System Notifications :- 03/12/2021 22:44:29 - The recording schedule has been automatically restored. 22/01/2022 04:23:16 - Automatically upgraded package tunefix-update from 1.0.112...

Both HDR's are hard wired Ethernet Via 2 seperate Hubs that are hard wired to Router, one is in the loft the other behind TV/HDR lounge, the laptop which can connect normally to the Lounge HDR is connected via WiFi.

My HDR in bedroom has sudenley started to overheat. When I tried to Log into WebIF from my laptop to check what was going on with the FanPackage I get this This site can’t be reached 192.168.1.23 refused to connect. I can play files on my lounge HDR via Foxlink using the same/normal IP address...

Does anyone know of a source of scematic/service manual for HD/HDRFOXT2

Just read this as well a see you cured it by my solution from previous reply [emoji4] Sent from my VOG-L09 using Tapatalk