Perhaps as you say there is a fault with it, but since it's so old won't be bothering to get it fixed. Might try one the independent firmware down loads to see if that changes things. Any recomendations?
It would go fully into standby "red display" then the Ae feed throught would shut down after a few seconds. Only when the unit was fully switched off using the mains switch, left for 20 sec and repowered up would the "off off" state work and allow the Ae to feed through. I can't remember what...
The two settings had been changed previously, I went through all the combinations switching to standby at each change. The Ae feed through went off each time. I then set to "off off" and switched the mains off and on, the feed through now works correctly.
Just doing some cable tidying up with my old Fox T2, took the tv aerial connection to the Humax Ae o/p and as you said goes off with the recorder. The power savings was set to off off as sugested with no improvement...UNTIL I powered the box fully off with the switch on the back of the unit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.