Recent content by Kevin2020

Thanks for the information. I will plan for having those board components replaced. But for now will keep with my interim solution: the unit's cover will stay partially off with a SATA 22-pin connector extension cable introduced between the normal 22-pin connector and drive. Then every time the...

Yesterday I gave up on letting my HDR-FOX T2 try to successfully complete booting in to use. Opening the unit and from experimentation I found after disconnecting the power lead to the internal hard drive that the boot-up successfully completed, but with no drive/disk running/powered. Then the...

Thanks for your response. But this has not been a one off issue. The booting has been problematic for months. And I've used the diagnostic tools to cure disk issues.

Yes it recovered. Perhaps something (some hardware) is indicating a failure during booting up that sporadically, after a number of reboot attempts, comes good - indicates OK. (If I now power down the device then I would expect a number of reboot attempts before it successfully starts up.) So...

My HDR-FOX T2 (with customised firmware) has had problems thru repeatedly rebooting after displaying the first HUMAX screen. So I leave it powered up. Anyway, about ten days ago the device rebooted itself and started repeatedly rebooting. I left it ooping, but last night it successfully...

Thanks for the feedback. The discussed replacement remote control (RC) was supplied without paperwork - let alone a user manual. So I am not convinced the supplier is an authority on the device and how it works. Or is eager to become an authority. Given the RC has exhibited enough memory to...

My original HDR FOX T2 RM-F04 remote control is over 10 years' old and some buttons becoming unreliable. So I purchased a cheap RM-F01/F04/E06 look-alike replacement (I believe) made by ALLIMITY. That new remote when in HUMAX/PVR mode works reliably/well. But the white TV, DVD and AUDIO mode...