Recent content by koshkakk

Normal ? Do you mean in terms of low noise ? Should it not be virtually flat at a constant 12V or 5.8V ?

Snap :-)

These are the voltages on the output of the switched power supply board (PW808 ), with the main processor board disconnected. Scale is 5V per division, 500 ms. What looks like a 1 at the extreme left, is zero. The 5V output:- The 12V output:-

Thanks

It would appear so :-( Is it possible to purchase a replacement from Humax ? PW808 which has an 8 pin connector to the main board. If so, what is the phone number please.

On the PSU circuit board ( PW808 ), the final jumper ( is that the correct term ? ). which connects to the main circuit board, has this written along the top where the 8 wires are attached:- +12 +12 G G +5.8 +5.8 G G So presumably, these are the 'expected' volts and G means ground ? I...

Most, if not all of the material concerning the 'Capacitor repair kit' I have seen on the Internet refer to the FOXSAT, however, in my Fox T2, the initial board (PSU) is labelled PW808, and to me appears exactly the same as the ones shown for the FOXSAT repair. I visited 3 Lidl stores, and...

Thanks, I will take a look.

I mentioned 'capacitors' because the only thing I found relating to the PSU PW808 was something called 'Capacitor kit' at various places on the internet ( sorry, I can't post links until I have a sufficient number f posts ). I'm just grasping at straws really. I don't have a volt meter. I am...

My HDR suddenly lost power whilst I was watching a recording. Here are the details:- 1 There are no lights shown on the front ( or back ). 2 I cannot hear any sound from the hard drive or fan. 3 I can feel a slight 50 Hz vibration on the bottom of the case 4 I have changed the fuse on the mains...

Thanks guys, it's all working now. I will read the instructions more clearly in the future. :frantic:

Gulp, how stupid of me. I went to the page and did not carefully read the headings. I just looked for some text that indicated 1.02.28 on the assumption that the whole page was customised firmware only. Anyway, many thanks, and I will give it another go.

I am trying to install the customised firmware and I would be grateful if anyone could shed some light on what my problem might be. Here is a subset of my details:- Humax HDR-FOX T2 Software Version FHTCP 1.02.28 Loader Version a7.30 System ID 80BC.7E00 Update date 26 may 2012 MICOM version...