Recent content by martyzzz

Thanks to all for your replies - the tip to do a manual restore worked well and saved a lot of time I did force a reboot immediately after the retune so I don't think that can be the reason for the auto part failing. However, now I know the manual route I will do that in future Thanks again

I have auto-schedule-restore installed and it has never worked after a re-tune. Please advise what I might be doing wrong! I am just about to reprogramme all of my recordings - deep joy Thanks

Logged on this morning and the EPG was fully populated without any further action. The EPG Region is now correctly shown under devices. Time is the healer? Thanks to all for your help

Thanks - tried that and a don't think id did anything this is all it showed >>> Beginning diagnostic rs/epgpush Running: rs/epgpush >>> Ending diagnostic rs/epgpush I will try in the morning

I have now tried the reboot from the webif using the round button marked reboot. I have then typed the rs/push and it ran to completion. Still no EPG so I have logged out of RS and logged back in again and still no EPG. The list of scheduled recordings does appear in RS, just not the EPG

Ok - it has been 2 hours now.

Thanks for your help. I now have the RS package installed and I have registered but the EPG does not populate with any program information. Am i missing something that I need to do to make the EPG work? In settings the EPG region shows as "Unknown" in the Devices section

I am not sure - I have the custom firmware and the web interface to the Humax If you know what i need to do could you please list the steps in detail?

The instructions to get started with this say: Go to the Settings page in your device's local web interface and register with the remote scheduling service; I can't find where to do this could somebody please help? Thanks