Recent content by Teg

My Humax reset randomly twice over the last 3 weeks. Cannot understand why as I have all the packages to stop a re-tune and there are no further OTA updates expected.

It's a Debian box with the latest version Stretch.

I have used the network share package successfully for many years. However, it has stopped working recently. I can still use the WakeOnLAN feature to boot my NAS but it is unable to connect to the share. The strange thing is I am able to connect to the NAS from other devices (Android TV box...

Thanks Black Hole! That worked a treat! Web Interface back working. I do notice some disk errors though so will run a full disk check over night.

Any suggestions? Shall I just load the latest Custom Firmware on top again? Any help greatly appreciated.

Yes same error.

Still not change. Any experts out there can advise on best thing to do? Can I just install 3.13 over the top and get the firmware to download the web interface a fresh?

Yep - but I will try again to see if I can get it to work as there was a gap (reboot) between the two commands being entered.

Tried all the above, still the same result. Is the best option to remove custom firmware and start from scratch?

Ran this command successfully but still even after reboot - only see top banner on the web interface.

Ran fix disk but still not working. Attempted to re-install web interface but got the following errors (see attachment)

Not sure which version of the Web Interface I am on. I am using custom firmware 3.13. I can only see the top banner including the current storage status pie chart. Nothing else loads. Is there a way to restart the web service from the command line. Any help greatly appreciated.

Yes I did get it back working again. However when I first got into maintenance mode successfully, I was unable to run the fixdisk diagnostic because the hard drive was still mounted. I thought part of going into maintenance mode was to un-mount the drive. The output from the Humax was frozen but...

Sorry to reopen an old thread but having the same problem. Rebooted my box a few times. Had the 51% Maintenance Mode issue twice then rebooted back to normal mode but had to reboot again to get the clock corrected. Any suggestions? Was this resolved by anybody else?

The telnet command returns no response. On the Web If itself the response is Package webif (2.87) installed in root is up to date. However still showing old version in settings - attempted a reboot but still no change!