Auto-decrypt and autoshrink not working

wibbers

New Member
Hello all.

Some time ago I replaced the original 500Gb drive with a new 2Tb drive. Previously to save space on the disc I had recursive autoshrink and autodecrypt on everything, always working well. I've just realised that since the changeover, new programmes are not being decrypted or shrunk, despite these settings being flagged in the file lists.

Manual autoshrink works as it should, but obviously it would be a lot quicker if the processes were automatic.

Any ideas on how I could get it working again? Thanks!
 
When you replaced the disk it will also have turned off content sharing on the unit. This needs to be switched back on if you have not done this already.
 
That would explain the "Note: Content Sharing is disabled on this system" at the top of the file lists. Where do I go to switch it back on? (Sorry - I'm an absolute novice with all this.)

Edit - found it. Thanks.
 
Last edited:
That would explain the "Note: Content Sharing is disabled on this system" at the top of the file lists. Where do I go to switch it back on? (Sorry - I'm an absolute novice with all this.)
You have to turn it on on the unit itself with the remote control:
Settings>System>Internet Setting>Content Share
 
Back
Top