Forces TV Failure

greywizard

Member
Recent few days when I switch to Forces TV on Freeview 96 the picture/sound are totally pixelated or frozen.
This happens whether I am watching channel via the 2000T or even when using the loop-thru.
I checked signal info on box and it showed continuous bit error and Strength/Quality around 22-40 %
I then checked the channel via my Samsung U43 Smart and the figures showed Multiflex as 13920,
Network com7 National (id 3045), Bit error 2000BER, Signal strength of 42% and Signal Quality of 23%,. The channel ID
shown as 55.
I did a retune but to no effect. I know over the past couple of years Forces TV has been moved about a bit!
all other Freeview channel signals (via box or through Loop-thru) are around Strength 72% and Quality 100%.
Any thoughts out there?
 
Right, well Forces TV is on COM7, which is UHF55 and 72kW as opposed to the other main muxes which are 100kW and UHF32-48.

However, Forces TV LCN96 shouldn't be any worse than BBC FOUR HD LCN106 (on the same mux). If the cohabiting services (see https://www.freeview.co.uk/corporate/platform-management/channel-listings-industry-professionals) show similar reception issues, you need to check your aerial has the right bandwidth - see https://hummy.tv/forum/threads/refe...nel-numbers-aerial-groups-how-to-choose.9224/.

Also check reception on the SDN mux UHF48 (eg Channel 5+1).
 
However, Forces TV LCN96 shouldn't be any worse than BBC FOUR HD LCN106 (on the same mux). If the cohabiting services (see https://www.freeview.co.uk/corporate/platform-management/channel-listings-industry-professionals) show similar reception issues, you need to check your aerial has the right bandwidth - see https://hummy.tv/forum/threads/refe...nel-numbers-aerial-groups-how-to-choose.9224/.
The Mendnip transmitter used to have other multiplexes at about the same frequency as 55 and so providing @greywizard did not change his aerial in 2019, (when Mendip underwent 700Mhx clearance), then it currently would have right hand width for force TV.

@greywizard another question for you. Did you have your aerial changed in 2019 (or later)?
 
It hardly matters - the installation might have degraded, or there could be more line-of-sight obstruction. Maybe the system was marginal. The data for other UHF55 and UHF48 services will tell much.

I had to shift my Mendip aerial down a group for the clearance, so I could easily have excluded 55/56 by not choosing a wideband replacement (as 55/56 might only be a stop-gap).
 
Not really relevant I know, but I noticed that Court TV was breaking down frequently whilst Forces TV was not. Both are on COM7. Either a problem with the link to the US or a fault in the UK distribution. Watched Forces TV last night and didn't have a problem so unless someone else on Mendip has the same problem my thoughts are red and herring shaped.
 
The Mendnip transmitter used to have other multiplexes at about the same frequency as 55 and so providing @greywizard did not change his aerial in 2019, (when Mendip underwent 700Mhx clearance), then it currently would have right hand width for force TV.

@greywizard another question for you. Did you have your aerial changed in 2019 (or later)?
No. Sticker on aerial states 07W40. Does this indicate I have correct aerial??
 
A belated reply to the above. It turns out my 2000T is not very good on loop through. Plugged TV cable directly into wall socket and perfect
reception.
 
Back
Top