Hummy Gav
New Member
Hi
I have noticed that my new HDR Fox T2 is a little slower than my 9200T, when I switch channels 
 
Its connected by HDMI to a cheap Tesco 19in LCD 
 
When I change channels sometimes I hear the sound of the next channel, but the screen goes blue(default blank screen colour of Technika) then the channel pops up.
It seems that it switches over then for a moment looses the signal hence blue screen.
 
I have now noticed that if I change the output to 576p from 576i this problem goes away, the blue screen is the TV switching via hdmi the output settings,so when using 576p there is no delay in switching channels,all very smooth.
Question is, is 576p worse than 576i for quality???
It could be just my cheap Tesco TV being at fault, anybody any ideas ??
Thanks
				
			I have noticed that my new HDR Fox T2 is a little slower than my 9200T, when I switch channels
 
 Its connected by HDMI to a cheap Tesco 19in LCD
 
 When I change channels sometimes I hear the sound of the next channel, but the screen goes blue(default blank screen colour of Technika) then the channel pops up.
It seems that it switches over then for a moment looses the signal hence blue screen.
I have now noticed that if I change the output to 576p from 576i this problem goes away, the blue screen is the TV switching via hdmi the output settings,so when using 576p there is no delay in switching channels,all very smooth.
Question is, is 576p worse than 576i for quality???
It could be just my cheap Tesco TV being at fault, anybody any ideas ??
Thanks
 
	

 , I must say I think my 9200T is better at SD via scart on my old Sony 28in CRT TV.
 , I must say I think my 9200T is better at SD via scart on my old Sony 28in CRT TV.
