HDR-T2 locks up on putting into standby

[af123]

Right, out from humaxtv.log, first, in response to using the real remote:
So it is seeing the remote attempt to power it back on.
Output from tzget shows it is getting the correct time:

Just for completeness - these results eliminate a hardware fault in the front panel as the cause.

Af123, is there any logs/settings files I can post that would help figure out what is causing this?

I can't yet work out why that would be causing this problem. The scanmounts.logs shows that the mount is failing with permission denied, which is something you might want to look at, but it shouldn't cause this bad behaviour in the Humax software.

 

[Black Hole]

For reference, one of my machines was found to be in this state (I did not check whether the WebIF was live). This one is on a lot of the time, and I happened to turn it off before going out for the day - when I came back the front panel was in standby but the disk was spinning, and it was unresponsive to handset or front panel.

If it happens again I will check things out.