Webif: Channel Group for EPG - empty

S

SunnysideUK

Member
After a completing a Wizard event my EPG was empty. Checking Settings|EPG Settings, the Channel Group for EPG setting only shows: "-None-"
with no others listed. I was expecting "Humax 4" or "Favourite 4" to be listed.
My remote EPG is listing OK and is set to "Favourite 4", renamed "Humax 4" as shown on the remote EPG,
I've rebooted but problem persists.
Any ideas how best fix this malfunction?
 
prpr said:
Your favourites no longer exist after the Wizard. You will have to set them up again.
Click to expand...
Understood, but doesn't a schedule backup restore them? (its rename is listed).
Regardless, webif settings pull down only showed -empty-
I was unable to screen catch the pull down so didn't post the grab,
However see later,,,,
 
This morning greeted with the Wizard again!
Having completed it the Channel Group for EPG pull down is now OK,
I don't know why its changed now.
 
Additional: Return problem.
During the Wizard retune I was given the new option of selection the region (West or South-West).
I'm South-West on Stockland Hill. I assume it's picked up signal from Mendip transmitter.
Has this transmitter increased it's power or changed it's channel assignment?
I understood it picked up at least Ch,34 (Stockland is 22-29). My signal strength remains the same on the Stockland transmitter.
On first retune, I left it to it while I got my breakfast. On return and a little later I realised I had no LCN.4 & 5 (and others not checked).
I did manual retune after checking the aerial!
This time it appeared to pickup the wrong transmitter as Ch.4 signal was breaking up badly.
I fixed by retuning manually again, but stopping at Ch,29 (the HD mux). Now its OK.

I've never had this region option come up before.
Any ideas on this and why a poorer signal mux was chosen over the better one?
 
SunnysideUK said:
Understood, but doesn't a schedule backup restore them? (its rename is listed).
Click to expand...
I don't know. I've never tried it with favourites as I don't use them.
SunnysideUK said:
Has this transmitter increased it's power or changed it's channel assignment?
Click to expand...
No. (And there's no apostrophe in possessive "its".)
It's probably down to the high pressure and the time of year.
I've never had this region option come up before.
Click to expand...
It happens if you see multiple transmitter regions. Sometimes having a selection of attenuators you can temporarily insert in the aerial feed whilst tuning is useful, to drop the unwanted signals below threshold without affecting the wanted ones too much.
Any ideas on this and why a poorer signal mux was chosen over the better one?
Click to expand...
Humax wrote a crap algorithm.
 
prpr said:
Sometimes having a selection of attenuators you can temporarily insert in the aerial feed whilst tuning is useful, to drop the unwanted signals below threshold without affecting the wanted ones too much.
Click to expand...
Or do a manual tune of just the desired UHF channels, or use tunefix...
 
You must log in or register to reply here.
Back
Top