I've run it again, for 10 hours, with the same result.
I feel a little reluctant to go for a beta version - I only have the one system (which I used for all my TV watching, and I don't want to risk running into serious issues with it.
Are there any options for Fix-Disk that might be useful in...
I've now loaded the latest firmware, but this has not resolved the problem:
Menu version 1.20
Enter system PIN: ****
/---------------------------------------------\
| M A I N T E N A N C E M O D E M E N U |
\---------------------------------------------/
[ Humax...
I have tried several times to run Fix-Disk to check for problems on the internal drive of my HDR-FOX T2, but each time Fix-Disk stops running at the same point. (I know that Fix-Disk can take several hours to run, but in 10 hours the operation does not progress any further.) The report is as...
Is this what you need?
SMART Status PASSED
Device Model WDC WD20EURS-63S48Y0
Serial Number WD-WCAZAJ209569
LU WWN Device Id 5 0014ee 2b21f7fbc
Firmware Version 51.0AB51
User Capacity 2,000,398,934,016 bytes [2.00 TB]
Sector Sizes 512 bytes logical, 4096 bytes physical
ATA Version is 8...
Any suggesions, from anyone? Should I replace the drive? If so, what drive would be suitable? (All the recommendations that I have found by looking through earlier threads have been discontinued!)
I purchased the drive a year or so ago, to install in my previous HDR-FOX T2, which I abandoned shortly afterwards. I kept the drive, and have now installed it in the replacement HDR-FOX T2.
I've now run the diagnostics, but I'm not sure how to report them. Should I simply copy and paste into...
I recently upgraded my HDR-FOX T2 by installing a 2TB HDD. (To do this, I updated to the latest custom firmware, physically installed the drive, let the firmare setup the drive, and copied across the media files.) All seemed to be well, but after a few days, the Humax started to freeze for no...
I am about to upgrade the HDD of my HDR Fox-T2 to 2TB. I have read the Wiki entry on this topic, but am a little uncertain about dealing with the block/sector alignment issue. I have also read elsewhere of a procedure for cloning the drive using PartedMagic ISO image file, and this does seem...
In my case, I got the message saying that there were no channels stored and was then taken to the tuning menu when I clicked "OK". And, yes, this happened yesterday. But 2 days earlier, there was an unexplained failure of a scheduled recording. It did not result in loss of channels, but I do...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.