1800T not responding to Humax remote RM-H06S

H

HumaxFan007

New Member
Can anyone suggest why my Humax 1800T Freeview has stopped responding to its remote control (RM-H06S)?
What I've tried:
1. Have put new batteries in the remote - but to no effect.
2. The 1800T's remote works with another Humax (a Foxxsat HDR) - it can turn it on and off, and change channels etc. So it looks like the 1800T's remote is working ok.
3. The on/off button on the 1800T front panel turns it on/off. When it's on, the screen displays the screen-saver clock but nothing else.
4. Before the 1800T stopped responding to its remote, its display showed recorded programmes, and I could use the remote to play them.

Question: might the 1800T's remote have lost its link to the 1800T, somehow? If so, how might I re-register it?

I hope someone can help!

Martin
.
 
Have you tried disconnecting the 1800T from the mains and then reconnecting? That might get the Humax to show something other than the screen saver. If it boots up properly to show a normal display the remote might be recognised.
 
Thanks to everyone. I guess it's likely a broken IR receiver.

But just in case my 1800T's remote has lost its link to the 1800T, is there a way to re-register it to its parent 1800T.? The remote (RM-H06S) doesn't have a PVR button, so the ploy of pressing and holding the 0 and OK buttons on the remote until the PVR button glows red isn't available!

Martin
 
Last edited:
HumaxFan007 said:
3. The on/off button on the 1800T front panel turns it on/off. When it's on, the screen displays the screen-saver clock but nothing else.
Click to expand...
Have you tried the channel up/down buttons on the front panel? If you can't move away from the screen saver clock by this method you may have bigger problems than the remote.
The 2000T (essentially an 1800T with slight changes) will do a proper reboot if you hold the front panel on/off for a few seconds. Be aware it may switch itself off after the reboot (my 2000T did when testing).
HumaxFan007 said:
The remote (RM-H06S) doesn't have a PVR button, so the ploy of pressing and holding the 0 and OK buttons on the remote until the PVR button glows red isn't available!
Click to expand...
The instructions I've seen would require the 1800T to be on and working. Any other Humax off. Hold 0 and OK for (about) 5 seconds and there should be a code selection message on the TV.
 
Black Hole said:
I have no experience of the 1800T, but this seems ominous to me.
Click to expand...
And me. I do have the vaguest recollection of something similar - but that sorted itself out after a full power off (as in take the plug out of the wall socket), wait for whatever, and reboot.
 
You must log in or register to reply here.
Back
Top