These don't get the programme listings so cannot be set up for automated recording.
I have done a search and find various procedures which (despite having a degree in electronics and being a hardware/software designer) I find impenetrable. It is something to do with channels being transmitted in groups from different transmitters, etc.
In our area, just N of Brighton, the TV aerials can point in one of two directions and obviously ours was installed to point in one of these, but we can't achieve both with one aerial![Smile :) :)](/forum/styles/default/xenforo/smilies/smile.png)
Is there some simple procedure?
The Fox T3 firmware is v a7.33 and this is a modded version which enables various tricks which I have used years ago (e.g. decrypting recorded programmes into mpegs) but don't need anymore. A few years ago we went through a period when the box was rebooting quite often (apparently something in the received freeview data stream) and reloading the same software fixed that.
Many thanks in advance.
I have done a search and find various procedures which (despite having a degree in electronics and being a hardware/software designer) I find impenetrable. It is something to do with channels being transmitted in groups from different transmitters, etc.
In our area, just N of Brighton, the TV aerials can point in one of two directions and obviously ours was installed to point in one of these, but we can't achieve both with one aerial
![Smile :) :)](/forum/styles/default/xenforo/smilies/smile.png)
Is there some simple procedure?
The Fox T3 firmware is v a7.33 and this is a modded version which enables various tricks which I have used years ago (e.g. decrypting recorded programmes into mpegs) but don't need anymore. A few years ago we went through a period when the box was rebooting quite often (apparently something in the received freeview data stream) and reloading the same software fixed that.
Many thanks in advance.