EPG not showing - No cached EPG data, try again later (no such table: epg.epg)

A

aks100

New Member
I am not seeing the EPG anymore via the web i/f, I don't know when it stopped working, but it has previously been fine. However, the on-screen EPG is working fine. When I hover over the title area, it shows "No cached EPG data, try again later (no such table: epg.epg).
BBC ONE Lon.png
Watching 1: BBC ONE Lon".

I searched and found a this similar thread, and I 've tried a few things, like restart the epg service, cold reboot of the Fox-T2, leave on BBC1 for 30 mins (and BBC1 HD), but I still do not see the epg.

Custom firmware version is 3.13 (build 4028), and web i/f is 1.4.8-1.

I just did a re-tune too, still not showing any EPG entries in web i/f.

Thoughts on how to resolve this, or reset everything and re-install custom f/w?
 
aks100 said:
Thoughts on how to resolve this, or reset everything and re-install custom f/w?
Click to expand...
Reboot into Maint mode (from the Diagnostics menu) and run the menu option to clear the epg database
(simpler than doing the system flush)
 
aks100 said:
Thoughts on how to resolve this, or reset everything and re-install custom f/w?
Click to expand...
Is this an HD or an HDR?
Resetting and re-installing won't achieve anything... apart from wasting your time.
From a command prompt, what does ls -lR /mnt/hd1 say?
Maybe partition 1 has gone read-only, in which case you need a fixdisk run from maintenance mode.
 
I went to maintenance mode, tried to clear epg, but that failed to find the epg file.

I then ran fixdisk, and it dealt with a bunch of errors. After that, rebooted, and finally the web i/f epg is working again.

Thanks
 
I am experiencing a similar problems on the web i/f but none of the suggested solutions in this and a previous post have worked.

1, It started with the message "No EPG data for this time range..." on about 4 strange channels in the 800 range. No other channels were displayed.
Did an epg reset in maintenance mode. This resulted in the message covered in this post.
2. Did a fixdisk in maintenance mode. There were no errors but above message remained when system rebooted and left for some time.
3. Tried a further epg reset and got the message "EPG data partially cleared, some expected files were not found."
4. From a command prompt, I did ls -lR /mnt/hd1.
humax# ls -1R /mnt/hd1
/mnt/hd1:
dvbepg
lost+found

/mnt/hd1/dvbepg:
epg.dat

/mnt/hd1/lost+found:
humax#

The Humax on-screen epg has worked all along.

Any advice would be appreciated
 
You must log in or register to reply here.
Back
Top