1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HDR-FOX T2 - customised firmware but can't connect in web browser. Help!

Discussion in 'HD/HDR-FOX T2 Customised Firmware' started by tank121, Dec 28, 2012.

  1. tank121

    tank121 New Member

    Just completed the install using a usb stick and the tvportal seems to work and I can confirm it looks different to the standard portal.

    However, I'm unable to connect using a web browser to the specified ip address shown on the box 192.168.0.5.

    I can ping it fine.
     
  2. tank121

    tank121 New Member

    The box is connected via a wired connection to my virgin media superhub.
    Anyone?
     
  3. tank121

    tank121 New Member

    Sw now shows on system information as
    Fhtcp 1.02.29 has the custom firmware install from usb worked?

    On the Humax logo screen on startup it say a7.30
     
  4. varkanoid

    varkanoid New Member

    sounds like you have not installed it. Please describe the steps you took to upgrade to 1.02.29 firmware and 2.14 custom firmware.
    If you have installed the custom firmware correctly you should see SW 2.14 on the display at the front of the Humax when you turn it on from a cold start.
    Also open a CMD prompt and type telnet 192.168.0.5 you should see Humax# as the response. This is also prove you can connect to the Humax.

    It pays to look for the answers on here too yourself.
     
  5. tank121

    tank121 New Member

    Sorted I'd sussed it earlier I'd downloaded standard firmware again doh! All sorted now including remote scheduling recording, however I can't see any option on the remote scheduling Page to restart the Humax. I can only see this when connecting on the land epg. I believe a restart is required for the recordings to work?
     
  6. Ezra Pound

    Ezra Pound Well-Known Member

    It is not possible to force an instant reboot from the Remote schedule screen because it is not in 'live' contact with your Humax. The Humax contacts the remote Schedule server when it wakes up, the RS server never initiates contact with your Humax. The Humax has to 'wake-up' twice before info. from the RS server is fully entered into the recording schedule, It is possible to request that the Humax performs this 'Double wake-up' in one go from the RS server options
     
  7. tank121

    tank121 New Member

    Thanks for your help where exactly do I find this Double wakeup?
     
  8. Ezra Pound

    Ezra Pound Well-Known Member

    If you select a program from the RS EPG for recording and then go back to the Home page you will see a screen like this
    RS-reboot.jpg

    If you click on Schedule Reboot your Humax will contact the RS server and receive two messages, one to record 'Flubber' and one to do a second wake-up