Humax greenscreen on some tvs

It will seal low-pressure plumbing (waste pipes), but don't expect it to seal a leak in a mains feed. Great for making rubber handles on tools.
Click to expand...

Apparently good enough to fix a mechanically constrained but weeping joint in vented CH pipework until it gets drained. I was quite pleased to find a few inches at the bottom of the toolbox so avoiding a SF/TS trip. However this is a 90s system with no HDMI interface!

Not equivalent but possibly useful is Nano Gel Tape.
 
I've seen it but I didn't realise what it is! Perhaps we could use nano-tape for climbing skyscrapers (a la Mission impossible).
 
Last edited:
Just confirmation that this worked for me with a minus pin 19 cable and the vformat macro saved as boot.

Intact cable doesn't work with macro at boot or via remote just pressing vformat button.
minus pin 19 cable works with macro at boot

Tested both by turning off then on the device from the rear switch.
Pressing power on remote turns on the Humax, and maybe 10-15 seconds later channel appears on TV screen.
 
You must log in or register to reply here.
Back
Top