• The forum software that supports hummy.tv has been upgraded to XenForo 2.1!

    This upgrade brings a number of improvements including the ability to bookmark posts to come back to later. Please bear with us as we continue to tweak things and open a new thread for any questions, issues or suggestions in Site/Forum Issues.

Move to specified time

blimpyboy

New Member
I can do this easily on my Foxsat-HDR, when playing a recording I just use the numeric keypad on my remote to enter a time and it jumps immediately to that point in the recording. When I try this in my HDR-FOX T2 I just get the 'no way' (circle with diagonal line) symbol. Anyone any idea if it's possible to jump to specific time on the HDR-FOX T2?

It would be particularly useful when you have a dozen 4hr recordings to catalog taken from BBC RB1 in recent European Championships in Glasgow! ;-(


Thanks & regards
Ian
 
OP
B

blimpyboy

New Member
Genius! You have no idea how much time this will save me, thank you! This turns out to be even neater than the way I do it on the FOXSAT-HDR as it gives very fine control - it's even non-linear and speeds up as you hold the left/right buttons. I can go from start to near the end of a 4hr recording in seconds.


Regards
Ian
 

MymsMan

Ad detector
Genius! You have no idea how much time this will save me, thank you! This turns out to be even neater than the way I do it on the FOXSAT-HDR as it gives very fine control - it's even non-linear and speeds up as you hold the left/right buttons. I can go from start to near the end of a 4hr recording in seconds.


Regards
Ian
I find the non-linearity a bit of problem at times - I am just closing in to the target point when it speeds up and overshoots.

An alternative if you have the customised firmware is to use the webif to set a bookmark at the required time and then skip to the bookmark when watching.
 
Top