My original HDR FOX T2 RM-F04 remote control is over 10 years' old and some buttons becoming unreliable.
So I purchased a cheap RM-F01/F04/E06 look-alike replacement (I believe) made by ALLIMITY.
That new remote when in HUMAX/PVR mode works reliably/well. But the white TV, DVD and AUDIO mode buttons do not program like a HUMAX original remote.
After holding those mode buttons down for three seconds-plus they do not illuminate to enable entering of a target device's 3-digit code.
The seller (at Aliexpress) could not help with alternative programming advice.
So does any one know how to program this look-alike remote control to drive other devices/TVs?
(Note: the remote outputs infra-red in TV, DVD or AUDIO mode, so I am guessing there is a potential to re-program those modes.)
So I purchased a cheap RM-F01/F04/E06 look-alike replacement (I believe) made by ALLIMITY.
That new remote when in HUMAX/PVR mode works reliably/well. But the white TV, DVD and AUDIO mode buttons do not program like a HUMAX original remote.
After holding those mode buttons down for three seconds-plus they do not illuminate to enable entering of a target device's 3-digit code.
The seller (at Aliexpress) could not help with alternative programming advice.
So does any one know how to program this look-alike remote control to drive other devices/TVs?
(Note: the remote outputs infra-red in TV, DVD or AUDIO mode, so I am guessing there is a potential to re-program those modes.)