TV display crash on scheduled reboot.

MarmiteSandwich

New Member
I installed scheduled recording recently and did some testing. See thread re volume level. The scheduled wake up and sleep were at 10:00 and 10:15. At 09:03 today I woke up the Humax manually, and changed the wake up defaults (volume and channel). At 09:08 I put it to sleep with the remote. Then I scheduled a recording for 10:55 via the scheduled recording web page. At 09:58 the wake up occurred, and stuff happened up to 10:00 (see attached screen shot picture12). At 10:15 the unit did not go to sleep and the scheduled recording did not occur. At 11:30, by which time the recording should have finished, it was not visible on the Humax web interface, and the web interface was still running, although it should have been asleep (see attached screen shot picture13). When I attempted to check this out on the TV, the screen was frozen, showing the default timer screen saver, fixed and immobile at 10:15:01, the time when it was supposed to shut down. The remote has no effect. I will now restart by power cycling the Humax.

Am I doing something wrong, or is there a known problem with scheduled recording/scheduled power on/off? I can cope with this kind of thing from time to time, but other users in the household can get a bit uppity about it.

Web interface version: 1.0.16-3
Custom firmware version: 3.00 (build 2137)
Humax Version: 1.03.12 (kernel HDR_CFW_3.00)
 

Attachments

  • Picture12.GIF
    Picture12.GIF
    86.8 KB · Views: 8
  • Picture13.GIF
    Picture13.GIF
    59.3 KB · Views: 8

Ezra Pound

Well-Known Member
An alternative to the daily Wake-up and sleep is remove them both and instead manually set up a 'reminder' that is repeated daily, there have been reports of problems with wake-up / sleep pairs in the past, although this is usually due to one of the pair being removed or disappearing. A reminder is similar to manually setting up a record request, but the unit just wakes up and outputs video without recording
 
Top