Recent content by Engeeaitch

Thank you - I didn't realise that the channels were only updated daily. rs push channels did the job. Thanks again.

I've been using the remote scheduling service for years. It's been a great service, thank you. However, I have a problem at the moment... I have a number of channels setup in Favourites 1. Using the webif, these show correctly in the EPG Guide. However, on the remote scheduling service, only...

SOLVED!!! - It turned out that it was a (very old) faulty power supply to a router that I was using that was putting interference into the earth. Even though I tested by disconnecting the network cable from the Hummy, because the other network cable was connected to the TV, the earth was...

Thanks for all the advice. Having read the earlier post, I have tried: - Using a filtered mains supply - Using a SCART lead instead of the HDMI lead - Swapping the front panel (again) - the panel from the faulty unit worked fine on the good unit, and the panel from the good unit showed the...

Hi - I have recently picked up a second hand unit to use as a spare. It seems to work fine for some of the time, but then starts to act as if there is a phantom remote control in the room, with channel changes (up and down), shutdowns, startups and volume changes. Here is what I have done: -...

Hi - I was able to get to my parents at the weekend. They have a Humax 9300T which as far as I can tell, doesn't have any support for Audio Description. However, I was able to set this up on their Panasonic Viera TV - the volume of the Audio Description can be independently controlled, and it...

If I bought an identical second box and used that just for audio description, do you think I could run both boxes with the one remote control? Sent from my LG-D855 using Tapatalk

Hi - ideally this would be Freeview - there is no satellite dish installed at their house.

Hi can any of you knowledgeable and creative types out there help me with this one please? My parents are in their 90s. My mother has very poor eyesight, but my father’s is OK. My mother would benefit from being able to use Audio Description, but this would be very irritating for my father...

Thanks - I am currently using that to turn the unit on, but I want a power off code, so that I can turn everything off with one macro, regardless of its current state.

I am a recent convert from a Toppy to the Hummy HDR T2 (and wishing I had made the move earlier). I've been really impressed by the community support and the tools available. Thanks (have made a donation). One thing that is missing is a discrete power code that I can use on a programmable...