FOXSAT-HDR: Can I gain access to existing recordings in the absence of an LNB connection and no channels tuned in?

[HugeMaximum]

However, reading the CF Documentation around the Channel Editor it's unlikely to work I feel...
See CF Documentation: Channel Editor: Some Important Information Tab as the 'nothing stored' data probably trumps the CF channel editor update...
Certainly seems to on mine (showing a very old Channel Edit list in the WebIF but no dice for watching the recordings on a connected TV, other than via streaming after reboots). It'd not been switched on in a very long time.

I have two Foxsat-HDRs:
The one, mentioned above, now stuck in the tuning/no signal (as LNB disconnected and factory reset).
Both running CF so I can, potentially, do the necessary file copy/paste manipulations before (re)connecting the second one to my dish to (re)gain access to the Media files in the Humax UI after a proper freesat tune.

On a Foxsat-HDR (with custom FW) with no tuned channels (in "setup Wizard" state), maybe can telnet in and copy the FOXSAT-HDR_channels_backup.fcl file back to /dev/mtd6 - then reboot the box. If by some chance /dev/mtd6 can't be copied over (e.g. because it may be 'locked' as in use), then maybe try stopping the settop process, copy the file, then reboot the box.

 

[HugeMaximum]

Important to say the the commands are those issued on a telnet session into a Foxsat-HDR that has custom firmware! Edited earlier post to point that out.