If either a channel or software update is done ;do I need to factory reset my FVP-4000T STB ?
Either by connecting the box to the Internet (although the last I heard the roll out of the current software version had been paused because of some problem reports) or by by downloading a file from the Humax support site, unzipping it and copying it to a USB pen drive that you insert into the Humax.Well how do you update software then please only I cant see an option for software only chanels
As I said, the last thing I heard was that Humax had paused the roll out of the latest software so until that restarts you can't get the update over the Internet. No the update will not reset the settings but will wipe the schedule of future recordings; however the latest version of the software will retain, as far as possible, the schedule in future.It is connected to the internetbut I cant see any of the new update and , when its installed will ut wipe to factory settings please
I have merged your new thread with your previous thread on the subject. The latest released version has not changed.On the FVP-4000T how do you perform a software update please and what is the latest version of the FVP-4000T software? Also, does it tell you when a new update is ready and install it automatically or do you have to look for one.?
[The above] is largely correct for owners of the RM-L08 remote control (supplied with newer FVP-4000T boxes), but for owners of older boxes with the RM-L03 remote control, there is no 'FreeviewPlay' button, so all references to this should be replaced by the 'HOME' button.
There is... no need to use the rear USB port, the side one also works, and in my experience is much more convenient to access.
I don't have one to check, but I do not expect it to restore factory defaults as a result of updating the software. The HDR-FOX doesn't, and logically if a unit reset all the user configuration (tuning, recording schedule, output preferences, etc etc) as a result of software update, there would be a lot of very annoyed Humax customers every time there was a new software release automatically downloaded and applied.when its installed will ut wipe to factory settings please
How can the documents predate the revised handset if they explicitly refer to a button that only appears on the revised handset?But I suspect the documents pre-date the release of the revised remote control.
The incorrect details are in the Humax documentation, I have already mentioned the USB port, there is also the part about saving the software to an empty USB stick, this is not necessary.What detail is not correct (within the stated parameters)? Any errors are within Humax's own documentation.
Please could someone advise me? I have the Humax FVP-4000T I have a problem where the picture and sound are constantly freezing like a stuttering. Signal test show both strength and quality at 100%. I have tried removing the airel and retuning to reset then replacing airel and retuning channels. I don't know what else I can do?
Sent from my SM-A320FL using Tapatalk