BMAX
Active Member
Been there, done that, no difference.Try a factory reset. It won't delete any recordings but will wipe your schedules.
Would be interested to see if it makes a difference.


Been there, done that, no difference.Try a factory reset. It won't delete any recordings but will wipe your schedules.
Would be interested to see if it makes a difference.

They will be greyed out if the box is recording (or thinks it is recording). If there is a recording taking place then wait until it has finished; if not put the box into standby, wait until the disk stops spinning (maybe 30 seconds) and then turn off the power. Wait 10 seconds and then turn on the power again. Box will boot and go into standby. Bring it out of standby and you should be able to do the reset to default settings.ust seen the last post and went to the settings to maybe try a factory reset BUT installation and channel lists in the menu are greyed out????
Your software version (1.02.20) is quite old and Humax have made changes to HDMI handshaking in newer releases, I would try 1.02.32 (Link HERE), there are instructions for installation on the WiKi HERE1.02.20 . . . should these be higher?

. It's difficult to say whether newer releases have fixed all HDMI problems, I suppose we are seeing less of them being reported, but I think that is due to newer TVs being more compatible than old ones. It has been reported for a long time that there are more HDMI green screens when a user turns on the Humax while it is recording from standby and I think this is still the case with the latest 1.03.xx firmware, as I had this happen the other day with 1.03.06